Sunday 25 April 2010

My Nerf Armoury Vol.3 - Raider CS-35

In my opinion the Raider is an awesome gun. It's range isn't anything like modded Nitefinders (or my Big Salvo, which will be in my next post) however what it lacks in power, it easily makes up in rate of fire and ammo capacity.

Here is a picture-filled Raider review by SG Nerf

Disclaimer: Modifications may wear out or damage your blaster, I take no responsibility for people trying to do the same as me and breaking any part of their blaster.

I did a few mods to my Raider, the first was an Air Restrictor (AR) removal, by using the "pipe-cutter" method. I found that cutting slightly closer to the dip achieved a better result as the inside section then had more pipe to glue to (ask if your performing the mod and your not sure what I mean). I did not put any padding to protect the plunger tube.

I took off the safety catch which only lets you prime the blaster if there is a magazine in it, it was quite obvious what it was and was simple to remove. This lets me load darts into the gun by hand, by doing this I can push the darts in further than they would otherwise go.

I did a "power stock" mod for the blaster. This mod makes the blaster harder to prime but adds around 10' to the range. I used a maverick spring and ended up gluing it to the plunger tube to improve reliability. The mod involves cutting the end of the plunger tube cover off, gluing a short plastic piece to the plunger and putting a spring in between the plunger and inside of the stock (again if you have questions please ask). Here is a picture of what it looks like when I take the stock off and prime the blaster:
 
 
The stock streamlines used to tend to swerve at around 20' making the gun useless at any range above that, however they are now accurate to around 30', or 35' if I load the darts singly.

I will probably add to this post after I have some more Nerf war experience with the blaster.

4 comments:

  1. Hi, Some advice. I have modded a raider and i would advise putting some electrical tape over the air release valve. To avoid damage to the plunger tube I used a power drill to get the AR out of the gun. Hope this helps.

    ReplyDelete
  2. You did a great review about it. I am thinking to get one for my nephew but I think that you should add the link to at least a e-retailer like amazon or best buy.

    ReplyDelete
  3. Could use some help with mine . I need some pics of the magazine slot internals, catches, springs etc. Had dismantled it for spraying and have Lost the pics I took for rebuilding it. Am familiar with all the other internals. Just cant figure out the mag slot !!!

    ReplyDelete